Scw networker pro camera in other subnet

We used to be able to scan another subnet 192.168.10.0/24 in our network, but we are no longer able to do so, and nothing has been changed on the scanner so far. Would this accomplish what I'm trying to do?ДЄny issues with performance given the Linksys is 1.5ghz dual core / 512 DDR3, and the ER-X is 500mhz dual core / 256 memory?Д¬an I configure the VLAN/firewall rules through a web interface or will I have to use CLI? However, when we run a Nessus host discovery scan on 192.168.2.0/24 and 192.168.3.0/24. If my understanding is correct, even if I bought a managed switch for the IP camera VLAN, I wouldn't be able to access it from my trusted network without a router/firewall capable of VLANs.ДЇor around $180ish, I could get an Edge Router X and Unifi US-8-60W switch, and convert my Linksys into an AP.

Right now I'm running a Linksys 1900ACS as my router, but from what I've read, it's not capable of VLANs. For instance, viewing the camera from my phone if someone is at the door. You can connect to the NVR remotely and log in and use the NVR as a bridge to watch the cameras, but neither you nor a hacker can log into the cameras themselves, without either logging into the NVR or being physically present to plug into the NVR and possessing knowledge about your NVRs specific camera subnet mask. I would like to be able to access the NVR from my trusted LAN and mobile devices. Setup DHCP for new VLAN, and add VLAN address on Dashboard screen. ER-X run basic wizard, go to local switch on router and make VLAN aware and set the port for the US-8, pvid empty, and vid is your camera vlan.

I just picked up a couple Reolink IP cameras, and I've read it's best practice to isolate them (and the NVR) into a VLAN for security purposes. You will need an access point unless you intend to use your current router as an AP.

Scw networker pro camera in other subnet